Configuration Guide Lines in New Modems - MTNL Delhi

gazecummingNetworking and Communications

Oct 26, 2013 (3 years and 7 months ago)

62 views

Configuration Guide Lines in New Modems


(Model NO.: T
-
KD 318
-
EUI)

(Current Firmware Version :

R1.00B02.3AS.BL)


1. IP addresses of CPE:

a) On Ethernet Port:
192.168.1.1





b) On USB Port


:
192.168.1.2


i.e. Two IP addresses are allotted to ADSL Rout
er(CPE), Hence IP address
to be configured to computer (TCP/IP properties) will be:





From:


192.168.1.3


To: 192.168.1.34



2. TCP/IP properties setting on computer.


a)

Obtain IP address automatically. It will OK.

b)


If you want to assign IP address to C
ompter manually then:



IP address:



192.168.1.3



Subnet Mask:

255.255.255.0



Default Gateway:

192.168.1.1 …………. For Ethernet Port


Or

192.168.1.2 ……... For USB Port








Primary DNS:


203.94.243.70

Secondary DNS: 203.94.227.70


Guidelines to install USB Driver:
-

1.

First start installing USB Driver.

2.

During the installation process, you will be asked to connect the
ADSL Router Through USB port.

3.

Than connect the Router Physically to your
Computer/Laptop








TCP/IP properties Setting:


CASE

I

Abtain IP address Automatically:

















CASE II: Use the following IP addresses.




TCP/IP Properties Setting for USB:



















TCP/IP Properties Setting for Ethernet:










CPE configuration in PPPoE Mode




Parameters

Existing Settings

Required Settings

Connection Type

PPPoA VC Mux

PPPoE LLC

Default Route

Disabled

Enabled

NAT

Disabled

Enabled









CPE configuration in Bridge Mode:










Command to Save the conf
iguration


Tools
-
> Misc
-
> Save & Reboot, as shown below
















Setting in Firewall: