Programming the ROD microcontroller

fiercebunElectronics - Devices

Nov 2, 2013 (3 years and 8 months ago)

65 views

Programming the ROD microcontroller


Adam Davis 20
th

June 2007



Preparation before power
-
on


Ensure that you have the following equipment


-

Serial cable

-

Fujitsu FLASH MCU 16LX programming software on a PC

-

Programming file (download)

-

Programming adaptor


Pr
ocedure


Ensure that the Jumpers
PL7

and
PL10

(centre of board, component side) has been
made.


Remove pin 4 from header PL16 and connect to it using the programming adaptor and
serial cable with the other end connected to a PC.


Start up the Fujitsu softw
are and select :
-

Target Microcontroller = MB90F594AG

Crystal Frequency = 4MHz

Hex file
UserInterface_V1.0.mhx


Power the module on and press the Full Operation button on the software.


When the software finishes, close the Fujitsu programming software a
nd configure a
HyperTerminal instance to use COM1, 9600, 8
-
bits, 1
-
stop bit and no parity or flow
control. Power the module off, remove the jumper on PL7 and power the module
back on again.


The HyperTerminal should display a menu with three functions, op
tions 1,2 and 3.
Use this menu to see if the module is operating correctly.