VerUp Tool (ver 2.0.1), Note

loyalsockvillemobΔίκτυα και Επικοινωνίες

27 Οκτ 2013 (πριν από 3 χρόνια και 7 μήνες)

65 εμφανίσεις

VerUp Tool (ver 2.0.1), Note


1

Introduction

This Tool acts firmware update (writing HEXdata) to Network board for IB
-
20/21 Series.

This tool works on Windows95/98, and WindowsNT/2000. Howeve IPX/SPX protocol need to be installed on
WindowsNT/2000.


2

Opetati
on

2.1

Activating this Tool

When
activating

this tool, first
available

network adapter will be
list
ed in network selection menu. If Host has
only one
network adapter
, this menu will be skipped.




After selectinh network adapter, NIC search will be start auto
matically.




2.2

Main display

After NIC search has acomplished, NIC list will be shown.



List can be sorting. And mulitiple selection is possible by click holding Shift key and Ctrl key at same time.
Some printer which doesn

t support IPX, IP address doe
sn

t show , instad

Unknown


shown in the columu of
IP address. In that case, please refer to the Ethernet address (Mac address).

IB
-
2x Search

IB
-
2x Update

2.3

D
ialogue

menu for searching condition

From menu, when selecting Options
-
> Search Filte,
D
ialogue

menu for searching condition

opens.

You can set filter as the specific IP address or printer name only.



2.4

Timeout dialogue

You may set maximum time out for each commnications. (Normally you don

t neeed to change.)




2.5

Preference dialogue

This menu has two selection.




Reset the uni
t
…”

---

After updating firmware, reset command will be sent to printer, as the result the
printer will be re
-
booting automatically.




When Uploading to multiple units
…”

---

When updating
multiple

printer, confirmation menu will
pop
-
up each printer one by o
ne. If this selection has checked off, confirmation menu pop
-
up only the
first time. This might has a resk for updating wrong firmware onto wrong printer.



2.6

Select firmware

From
the

menu, selects File
-
> Open or press Browse button,
Select firmware dialog
ue will pop
-
up. Please
select HEX data (firmware
).






2.7

Uploading

firmware


From the menu, select File
-
> Upload or press Upload button to proceed the firmware upload. The confirmation
menu will pop
-
up before starting firmware upload.








(End of the page)

IB
-
2x Update