JSP0505Ax

basicgratisΜηχανική

5 Νοε 2013 (πριν από 4 χρόνια και 4 μέρες)

90 εμφανίσεις

ELECTRONIC INFORMATION FOR BIDDER’S AUTOMATION JSP
-
05
-
05
A


1.0

Electronic Information.

Electronic information, consisting of survey and design
information including but not limited to
3
-
dimensional design models,
cross
-
section
models, alignment data, and plan view geometry, does not constitute part of the bid or
contract documents. This electronic information will be distributed with the cross
-
sections or upon the contractor's request. This information, used for p
roject design and
quantity estimation purposes, is provided for the
bidder’s

use in automation of bid
estimating, contractor

furnishing
staking
, automated machine guidance and other
construction methods

if provided in the contract. This information shall n
ot be considered
a representation of actual conditions to be encountered during construction. Furnishing
this information does not relieve a
bidder or contractor

from the responsibility of making
an investigation of conditions to be encountered including,

but not limited to site visits,
and basing the bid on information obtained from these investigations, and the
professional interpretations and judgment of the
bidder or contractor
. The
bidder or
contractor

shall assume the risk of error if the informatio
n is used for any purposes for
which the information was not intended. The Commission makes no representation as
to the accuracy or reliability of the information, since the information may not be
representative of the sealed contract documents. Any assu
mptions the
bidder or
contractor

may make from this electronic information is at the
bidder or contractor's

risk;
none are intended by the Missouri Highways and Transportation Commission. The
bidder or contractor

assumes the sole risk of liability or loss

if the
bidder or contractor
does rely on this electronic information to its detriment, delay or loss.