DC Circuits - Kirchhoff’s Rules
Purpose: To study Kirchhoff’s rules as they apply to complex DC circuits.
Apparatus: Circuit board, 100 Σ resistor (R
), 10 Σ plug-in resistor (R
), 50 Σ plug-in
), 22 Σ resistor (R
), decade resistance box (variable R), switch, power
supply, digital multimeter.
Fig. 6-1 (I) Switch closed (II) Switch open
= 10 Ω
Kirchhoff’s rules provide a general procedure for analyzing dc circuits no
matter how complex they might be. The circuits of Fig. 6-1, (I) with the switch S closed
and (II) with the switch S open, will be used to test both the junction and loop rules,
which may be stated as follows:
1. The sum of the currents entering any junction in a circuit must equal the sum of
the currents leaving that junction.
2. The sum of the potential differences across all elements around any closed
circuit loop must be zero.
1. Measure each of the resistors, R
, before connecting them in the
circuit. Use the digital multimeter set for the most sensitive ohms range. Each of the
resistances should be recorded to at least 3 significant figures.
2. Wire the circuit shown in figure 6-1 above, with the switch S in the closed
position. Ask your instructor to check the wiring before you begin to make
3. Set the digital multimeter to measure voltages and set the range to 20V.
Measure the output voltage of the power supply (battery eliminator). It should be
approximately 5 volts.
4. Set the digital multimeter to the 2V range. Measure the voltage across R
adjusting the decade box so that the voltage across R
is as close to 2 volts as possible.
Record this voltage, keeping all significant figures.
5. Measure the magnitudes and directions (+ or -) of the voltage drops across each
of the resistors, including the decade resistance box. Record these measurements,
keeping all significant figures, in the data table provided on page 17.
6. Disconnect the decade resistance box from the circuit (one side is sufficient)
and measure its resistance as precisely as possible.
7. Open the switch S. Do not change the value of the decade resistance box.
Measure all voltages across the resistors as above and record these results in the table
1. Fill in the tables by calculating the current (to 3 significant figures) through
each of the resistors for each of the voltage measurements made above.
2. Carefully draw the circuit (I) corresponding to the case when the switch S is
closed. Show the direction of the current through each of the resistors. Identify and label
all of the junctions in this circuit. Identify each of the closed loops associated with this
3. Based on your measurements, calculate the sum of the currents at each junction
and the sum of the voltages around each loop. You must keep track of the signs of all
currents and voltages.
4. Do the same calculations as above (steps 2 and 3) for the circuit corresponding
to the case when the switch S is open (II).
5. Solve the circuit, using Kirchhoff’s rules, for the case when the switch is open.
Use your measured values of the resistances and the measured value of the voltage source
to calculate the current through each of the resistors.
Questions to Be Answered in the Report:
1. Do your measurements agree, within experimental errors, with Kirchhoff’s
rules? Discuss your results.
2. For the circuit in which switch S is open, how do your measured values of the
currents compare with the calculated values? What might account for any
3. If the voltage source had a significant internal resistance, would this affect the
4. For each circuit (I and II), what is the total power dissipated in the resistors?
Show how you calculated this result.
5. For each circuit (I and II), which resistor dissipates the most power? Justify